InFocus® Projector
 

Setup
Place the projector in proximity to the laptop and consider the presenter's needs in doing so. Extension cords may be necessary to position the projector in the optimum location for the room, class, and presenter.

1. Remove the projector from case and place in appropriate area
2. Remove the lens cap from the projector
3. Attach power cord to projector and to power source
4. Attach Cable-Wizard cable to the 1st connection point on the left-side of the projector (cable is clearly marked), the other end attaches to the back or side of the laptop
5. Connect the audio speaker cable (either end) into the laptop speaker jack and the other end into the Cable- Wizard cable hub
6. Connect the mouse cable (to laptop end) into the laptop mouse port and the other end into the Cable-Wizard cable hub
7. Power on the projector with the power button on the top of the projector or the power button on the remote control
8. Connect the AC Adapter to the laptop and to the power source
9. Power on the Laptop by pressing the power button on the keyboard area of the laptop
10. Focus the picture as necessary by turning the 'Focus Ring' for picture clarity
11. Send picture form the laptop to the projector with the appropriate keystroke from the list below
    • 'Fn' key and F3 (Gateway)
    • 'Fn' key and F12 (Micron)
    • 'Fn' key and F8 (Dell 3200)
    • 'Fn" key and F7 (IBM ThinkPad)

This keystroke may be repeated to toggle the signal

If the color of the projected image is too green, the Cable-Wizard cable is not connected to the projector properly (Disconnect then reconnect the cable).