ViewSonic®
 

Set-up
Place the projector in proximity to the laptop and consider the presenter's needs in doing so. Extension cords may be necessary to position the projector in the optimum location for the room, class, and presenter.

1. Remove Viewsonic Projector from case and place in appropriate area
2. Remove Lens cap from the projector
3. Attach power cord to projector and to power source
4. Attach VGA cord to the 'RGB in' connection on the side of the projector and to the same connection on the back or side of the laptop.
5. Power On the projector by turning the power button located on the front side of the projector directly above the power cord
    
   **NOTE**
   STANDBY (R)/ON (G) indicator flashes green while the projector is warming up, and then after approximately 45 seconds the indicator changes to solid green and a picture is projected on the screen. When flashing red the fan is cooling down (about 1 minute) and needs to change to solid red before turning the fan off.
    
6. Connect the AC Adapter to the Laptop and the power source
7. Power On the Laptop by pressing the power button on the keyboard area of the Laptop
8. Focus the picture as necessary by turning the 'Focus Ring' and 'Zoom Ring' for picture clarity
9. Send picture from the laptop to the projector use the 'Fn' and F3 (Gateway) F9 or F12 (Micron), Pressing the 'Fn' key and holding it down while then pressing the F3 key for a second or two until the picture from the laptop is projected onto the screen. This keystroke may be repeated to toggle the signal.